Switching The Link Alarm On And Off - Philips NZ-SCD450/79 Mode D'emploi

Switching the LINK alarm on and off

You can switch on the LINK alarm on the parent units.
The LINK alarm will beep when connection between the units
is lost.
1 Open the battery compartments (B-11, C-13) of the parent
units.
• Large parent unit: use a screwdriver and slide down the
• Small parent unit: slide down the cover (C-13).
2 Set the switches (B-7, C-12) inside the compartment to the
ON ( ) position.
3 Close the battery compartment covers (B-11, C-13).
• To switch off the alarm, set the switches (B-7, C-12) to the
OFF ( ) position.
cover (B-11).
Features
EN
13