Publicité
EN
Having fi nished working, inspect the power tool for damage by visually checking the exterior and the body and the handles. Check
the power cord with plug and its rubber gland, the action of the electric power switch, the ventilation openings for clogging, the
motor brushes for sparking, the noise level of the bearings and the drive transmission, and how the power tool starts and runs.
During the warranty period, the user is not allowed to disassemble the power tool or replace any components or parts, as this will
void the warranty rights. Any irregularities found during inspection or operation are indicative of a required repair that needs to be
done at the service centre. After fi nishing work, the housing, ventilation openings, switches, auxiliary handle and covers should
be cleaned e.g. with an air jet (with a pressure not exceeding 0.3 MPa), paintbrush or dry cloth without the use of chemicals and
cleaning agents. Clean the tools and handles with a dry, clean cloth.
O R I G I N A L
I N S T R U C T I O N S
25
Publicité
