Publicité
2.2.7. Method for fastening the safety belt on the patient's
It is advisable for this belt to be attached to the stretcher to ensure the complete safety of
the patients and guarantee compliance with the UNE-EN 1865 standard test that is
performed.
Put the female part of the buckle A and male part B in the position shown in the figure
below and insert the latter into the slot in the former. Once the assembly is firmly secured,
centre and tauten it, adjusting the tension of the belt at end C.
It is advisable to ensure that while the patient is on the stretcher, he/she is always secured
by the safety belts.
2.2.8. Dismantling-assembling the stretcher safety belts
Anchoring with a knot
To dismantle the belts, pass the belt through the slot in the buckle as shown in the following
figure. To assembly it, just follow the same process but in reverse order.
Rev. 7
05.24
OPERATING AND HANDLING
OF THE TGM-241 SERIES
11
Publicité
