Publicité
With the "A" knob we can loosen and tighten the assembly where and when it is
convenient. Unscrewing the knob "B" we remove the IV drip stand to the vertical position
perpendicular to the stretcher, then we twist the knob again.
The length of said drip pole may be lengthened or shortened pressing a small positioner
located on the inner side, raising the hook until the upper position is reached.
2.2.6. Method for fastening the safety belts on the patient's head and feet
Place the clasps (C) in the position shown in the figure above. Pass the male part of the
buckle (D) between the openings (C) until it is inserted into the female part B. Once the
assembly is anchored in place, centre and tauten the assembly, adjusting the tension of the
belt at ends A and/or E. Note: The foot belt is not fitted with the C openings.
Rev. 7
05.24
A
The maximum load allowed
for the drip pole is 6 Kg.
OPERATING AND HANDLING
OF THE TGM-241 SERIES
B
The maximum weight is indicated on
the drip rod by an adhesive like the one
shown above.
10
Publicité
