Publicité
2. Open the lid of the medication container
3. Pour a su cient amount (4–6 ml) of tap water (soft water) into the medication container
the lid. Shake the container slightly so that the remaining liquid mixes well with the cleaning liquid.
4. Open the lid of the medication container, pour out all the liquid and then fill it with enough tap water
(soft water) again.
5. Place the medication container on the housing
6. Press and hold the On/O control
then flashes orange quickly and the device switches to self-cleaning mode. The device will auto-
5
matically run for 10 minutes. Please make sure that there is enough liquid in the medication container.
Disinfection
Please observe the following points when disinfecting your medication container
set. Regular disinfection of the individual parts is recommended.
First, clean the medication container
proceed with disinfection.
CAUTION
Ensure that you do not touch the mesh if possible, as this may destroy it.
Do not use sodium hypochlorite disinfectant for disinfection as it may damage the atomiser.
Disinfection with ethyl alcohol (70–75%)
• Place the mouthpiece
Leave it to take e ect for 10 minutes.
• Finally, clean all parts again with water.
• Then dry all parts thoroughly. For more information, see the "Drying" section.
Disinfection with boiling water
• The medication container
utes in order to disinfect them. Ideally, distilled water should be used to avoid contamination and
1
for 3 seconds when the device is switched o . The LED display
4
and atomiser set as described in the "Cleaning" section. Then
2
11
and masks
9 10
, lid
and the mouthpiece can be placed in boiling water for 15 min-
2
1
and pour out the remaining liquid.
.
3
in a container and cover all parts with ethyl alcohol.
53
. Close
2
and the atomiser
2
Publicité
