Publicité
• The medication container
that di erent areas of application involve di erent requirements in terms of cleaning and hygienic
preparation.
NOTICE
• Do not clean the mesh or the atomiser set mechanically with a brush or similar, as this can lead to
irreparable damage and optimal treatment results can no longer be guaranteed.
• Ask your doctor for additional requirements regarding hygienic preparation (hand cleaning, handling
of medications/inhalation solutions) for high-risk groups (e.g. patients with cystic fibrosis).
• The water mentioned later in the cleaning instructions should be as soft as possible. Distilled water
is suitable for all cleaning steps except self-cleaning.
Disassembling
• Hold the device with one hand. The button
Press the button
with your free hand.
• Remove the mouthpiece
• Open the lid of the medication container
• Assembly is carried out in the reverse order.
Cleaning
The medication container
(
or
) must be cleaned after each use with warm (ideally distilled) water at a maximum temperature
9
10
of 40°C for about 5 minutes. To clean the medication container, please follow the self-cleaning instruc-
tions described below. Dry the parts carefully using a soft cloth. When completely dry, reassemble the
parts and place in a dry, sealed container or disinfect them.
• Please perform the self-cleaning function afterwards (see "Self-cleaning function" section).
and the atomiser set are intended for multiple use. Please note
2
with your thumb and pull the medication container
6
F
or the mask (
11
and the used parts of the atomiser set such as the mouthpiece
2
on the back of the device should face towards you.
6
or
) from the medication container
9
10
by lifting up the flap
2
51
horizontally forwards
2
.
2
1
on the rear
.
C
or mask
11
Publicité
