Publicité
7.4 Connecting the atomiser set
• Securely connect the part of the atomiser set that you would like to use (mouthpiece
or children's mask
9
mask
or children's mask
9
straps securely to the mask with a knot.
• Now move the device to your mouth and put your lips firmly around the mouthpiece. When using the
mask(s), please place it over your nose and mouth.
• Ensure that you have filled it up with liquid before switching on the device. Start the device by press-
ing the On/O control
• If the spray mist comes out of the device and the LED display
device is working correctly.
NOTICE
The most e ective inhalation is when using the mouthpiece. Inhalation when using a mask is only rec-
ommended if the use of a mouthpiece is not possible (e.g. for children who are not yet able to inhale
with a mouthpiece). When inhaling with a mask, make sure that the mask fits well and that the eyes are
not covered.
The flow rate for the medication is set to high in the factory settings of the device. You can adjust the
medication flow rate during use by pressing and holding the On/O control
LED display
flashes blue. You can switch from high to low nebulisation rate and back again. A con-
5
tinuously blue illuminated LED display
flashing blue LED display
Adjust the medication flow rate to your needs.
) to the mounted medication container
10
, you may use one of the straps included. Ensure that you tie the
10
.
4
indicates a high nebulisation rate of ≥ 0.25 ml/min; a slowly
5
indicates a low nebulisation rate of ≥ 0.15 ml/min.
5
2
5
47
, adult mask
11
. If you are using the adult
E
continuously lights up blue, the
for 3 seconds until the
4
Publicité
