Publicité
Eolo Induction aspiration unit
The Ref. 080533 EOLO INDUCTION is a practical
aspiration unit specially designed to be used within the
field of dental prosthesis. It allows the aspiration of
aluminium oxide, silicon oxide, resin dust, plasters, and
investments and, in general, any material used in the
dental lab. The unit's most important features are the
following:
Three-stage filtering circuit, including a filter-bag, a
cartridge-filter and a plate-filter in the clean chamber.
Indicator
of
the
"Obstruction/Filter Full" alarm. Long operation
alarm, which disconnects the unit after operating
continuously for more than three hours.
Electronic regulation of aspiration power.
Possibility
of
"automatic"
synchronizing the machine's start up with 2
micromotors and a sand blast.
Possibility of simultaneous operation in two working
places.
In order to achieve the unit's optimal performance and a
long working life, we strongly recommend to read
carefully the following operating instructions.
INSTALLATION
1. Carefully
unpack
aspiration unit. You will find a Ø 35 mm flexible
connecting hose inside the packing.
2. The machine has been designed to operate under the
workbench, but it can be placed anywhere else.
Choose a firm surface to place it, far from heat
sources, damp or vibrations.
3. Open the filter lid (D) and make sure the filter-bag is
correctly placed. Close the lid again.
4. Connect the unit's aspiration hose to the aspiration
nozzle (A). To do this, simply press it firmly. The
other end of the hose can be connected to a
micromotor, sand blast, dry trimmer or any other
similar device. In case you want to use the aspiration
unit in two working places simultaneously, you need
a "T junction for two working places (ref. 080530-
26)", supplied as an accessory.
5. If you want to synchronize the suction with
micromotors or other devices, connect them to the
rear power sockets (maximum 400 W).
6. Connect the power cord to a grounded 230 V, 50/60
Hz power source.
7. The unit is ready to be operated.
filter's
filling
mode
operation,
your
EOLO
INDUCTION
MAIN DISPLAY
Speed
level.
Disabled socket
Detected micromotor
USER CONFIGURATION
1. On the home screen,
hold down the key
.
2. Briefly press the key
again to enter
option 1.0 User.
3. Select the language by pressing the keys
4. Save your selection by pressing the key
OPERATION
1. Activate the main switch (3).
2. Press the key
mode.
Automatic mode: It is indicated by the green light
on. In this case, the suction unit works
synchronized with a micromotor, so that when
you step on the pedal, the suction starts
automatically and remains running until about five
seconds have elapsed after the pedal is released.
Manual mode: In this case, the suction works
continuously governed only by the key
3. The display will show the suction power (from 30 to
100%). Adjust the power acting on the keys
and
CUSTOMER
CONFIG.
1.0 User.
2.0 Devices
3.0
3.0 User
LANGUA =
HRMOTOR = 0h
HTMOTOR = 0h
to select Automatic or Manual
.
EN
Filter level
Warnings
English
y
.
.
.
13
Publicité
