Publicité
ENGLISH
23. Main brush
24. Main brush bracket
25. Guide wheel
Mixed tank. Fig. 3
1. Filter cover
2. Water valve
3. Dirt-tank release tab
4. Waste-water tank drain outlet
5. Dirt tank
6. Waste-water tank release tab
7. Filtering module
8. Dirt tank
9. Cap
10. Clean-water tank
11. Clean-water tank filling inlet
12. Dirt-tank emptying outlet
Self-cleaning base. Fig. 4
1. Dirt-tank emptying outlet
2. Clean-water tank filling inlet
3. Top cover
4. Indicator lights
5. Charging terminals
6. Infrared
7. Waste-water tank drain outlet
8. Alignment guide
9. Water tank
10. Dirt-disposal bag
11. Ventilation holes
12. Cable cover
13. Ventilation holes
14. Charging port
15. Ventilation holes
16. Clean-water tank sealing ring
17. Waste-water tank sealing ring
18. Filter cover
19. Pump air inlet
Water tank. Fig. 5
1. Handle
60
2. Lock tab
3. Clean-water tank
4. Waste-water tank
5. Waste-water valve
Note:
The graphics in this manual are schematic representations and may not exactly match the
appliance.
2. BEFORE USE
-
This appliance is packaged in a way as to protect it during transport. Take the appliance
out of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the appliance
when transporting it in the future. In case the original packaging is disposed of, make sure
all packaging materials are recycled accordingly.
Make sure all parts and components are included and in good conditions. If there is any
-
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
-
Do not remove the serial number of the appliance in order to keep a correct traceability of
it in case of assistance.
Warnings
-
Remove all objects around the robot vacuum cleaner such as clothing, papers, cables,
curtains, or other fragile objects which may block or slow down the operation of the robot
vacuum cleaner.
-
If the room to be cleaned is near a balcony or stairs, a physical barrier should be placed to
prevent the robot vacuum cleaner from falling and getting damaged, thus ensuring safe
operation.
-
Direct exposure to sunlight or heavy light contrasts may affect the correct operation of
the sensors. If this happens, the robot vacuum cleaner will cease operation. Move it to a
new location for it to start running again.
Installing the self-emptying base
-
Firmly insert the cable into the charging port of the self-emptying base as shown in Figure
6, and store the remaining cable in the corresponding storage compartment.
Place the self-emptying base against the wall on a hard, level floor leaving a free space of
-
0.5 metres on both sides, 1.5 metres in front, and over 1 metre on top. Fig. 7
-
Ensure good Wi-Fi coverage for a better App user experience. Then turn on the self-
emptying base and check that the indicator lights turn on as well.
ENGLISH
61
CONGA 14090 TWICE ROLLER HOME&FILL
Publicité
