Spektrum MR200 Guide De L'utilisateur page 6

4. Follow the procedures of your specific transmitter to enter bind mode; the
system connects within 15 seconds. Once connected, the LED on the receiver
will go solid indicating the system is connected.
5. Remove the bind plug from the BND port on the receiver before you power off
the transmitter and store it in a convenient place.
IMPORTANT: You must remove the bind plug to prevent the system from entering
bind mode the next time the receiver power is turned on.
6. After you've set up your boat, it's important to rebind the system so the true
low throttle and neutral steering positions are set.
Failsafe
The MR200 features Preset Failsafe that is ideal for most types of boats. With
Preset Failsafe, when the signal is lost all channels are driven to their preset
failsafe positions (normally low throttle and neutral steering). Failsafe positions
are set during the binding process (see step 3 of the Binding section).
Failsafe Operation if Receiver Power Only
• When the receiver only is turned on (transmitter is off), all channels have no
output, to avoid operating or arming the electronic speed control.
Failsafe Operation After Connection
• When the transmitter is turned on and after the receiver connects to the
transmitter, normal control of all channels occurs.
• After the system makes a connection, if loss of signal occurs, Preset Failsafe
drives all servos to their preset failsafe positions that were set during binding.
• When the signal is regained, the system immediately (less than 4ms) regains
control.
Receiver Power System Requirements
Power systems that are unable to provide the necessary minimum voltage and
current demands to the receiver can cause the receiver to fail. Some of the power
system components that affect the ability to properly deliver adequate power
include:
• Receiver battery pack (number of cells, capacity, cell type, state of charge)
• The ESC's ability to deliver current to the receiver
• The switch harness, battery leads, servo leads, regulators, etc.
The MR200 has a minimum operational voltage of 3.5 volts.
Note: The latest generations of nickel-metal hydride (NiMH) batteries
incorporate a new chemistry mandated to be more environmentally
friendly. These batteries, when charged with peak detection fast
chargers, have tendencies to false peak (not fully charge) repeatedly.
These include all brands of NiMH batteries. If using NiMH packs, be
especially cautious when charging, making absolutely sure that the
battery is fully charged. It is recommended to use a charger that
can display total charge capacity. Note the number of mAh put into a
discharged pack to verify it has been charged to full capacity.
EN