Spektrum MR200 Guide De L'utilisateur page 4

Feeder Antennas
The MR200 incorporates dual feeder antennas, offering the security of dual path
RF redundancy. The last 31mm is the active portion of the antenna and should not
be cut or bent over the end of an antenna tube.
During operation the receiver switches between the two antennas. Locating the
antennas in different locations in the boat improves the ability of the receiver to
see the signal in all conditions.
31mm
31mm
Installing the Antennas
For optimum performance, mount the antennas in an orientation allowing for
the best possible signal reception. Mount one antenna vertically through an
antenna tube as high above the water line as practical. Mount the other antenna
horizontally, typically just under the edge of the deck, using tape to fasten the
antenna in place.
Plugging In the Leads
Plug the servo leads into the appropriate servo ports in the receiver noting the
polarity of the servo connector.
(Bind, Battery port )
Binding
EN
324mm
199mm
s Signal
+ Power
- Ground
BND/BAT
(Steering port )
THR
STR
(Throttle port )
Antenna A
Antenna B