Publicité
Masonry Cutting Guard Assembly
A Type B (Type 27) grinding
wheel guard may not be
used for all tool operations. Do not discard
guard when not in use . Always reinstall wheel
guard when converting back to grinding opera-
tions .
To improve ergonomics of your grinder when
cutting masonry, gearbox must be rotated rela-
tive to the position of the switch as the tool
was assembled at the factory .
Rotate Gearbox
(Fig. 11, Fig. 12)
1 . Disconnect tool from power source .
2 . Completely unscrew the four screws be-
tween the gear housing and motor body .
3 . Rotate gear housing 90 degrees without re-
moving motor from the housing (Fig . 11) .
4 . After adjusting the position of the gear hous-
ing, screw in and tighten the four screws .
5 . The screw holding the guard release lever is
longer than the other screws (Fig . 12), this
long screw must stay with the guard release
lever when re-attaching gear housing for the
guard release button to operate properly .
6 . To install proper guard follow instructions in
the next section .
GWS11-450P_Final_20240417.indd 23
GWS11-450P_Final_20240417.indd 23
page heading
Assembly
90
DEGREES
Fig. 11
Fig. 12
(1)
90
DEGREES
23
4/17/2024 10:53:25 AM
4/17/2024 10:53:25 AM
Publicité
