Publicité
Disconnect the plug from the power source before making any adjustments,
changing accessories, or storing power tools. Such preventive safety measures
reduce the risk of starting the power tool accidentally .
Vibration Control Side Handle
(Fig. 1)
The Vibration Control Side Handle 2 is used to
control and balance the tool .
Securely thread Vibration Control Side Handle
2 into either side of gear housing, depending
on personal preference, comfort, and operation
being performed .
The Vibration Control Side Handle 2 should
always be installed onto the guard protected
side of the tool, see figure 1. Use the Vibration
Control Side Handle 2 for safe control and ease
of operation .
Hand Shield (Sold Separately)
(Fig. 1)
The Hand Shield 9 is to be used with backing
pads, sanding discs, and wire brushes to keep
fingers and hand away from work surface, sharp
edges, burrs and debris .
When using the Hand Shield 9, insert Vibration
Control Side Handle 2 through hole in shield
and then thread into housing . Ensure that Hand
Shield 9 is positioned between hand and back-
ing pad, sanding disc or wire brush .
16
GWS11-450P_Final_20240417.indd 16
GWS11-450P_Final_20240417.indd 16
page heading
Assembly
Lock Nut and Backing Flange
(Fig. 1)
Your tool is equipped with a threaded Spindle
4 for mounting non-threaded hub accessories .
Always use the supplied Backing Flange 5 with
a Lock Nut 11 . The Backing Flange 5 is keyed to
Spindle 4 . Always ensure that arbor diameter
matches accessory diameter . Accessories that
run eccentrically may burst .
4/17/2024 10:53:16 AM
4/17/2024 10:53:16 AM
Publicité
