Publicité
Disc Grinding Wheel Assembly
(Fig. 4, Fig. 5)
Do not use accessories that
run eccentrically. The tool
will vibrate excessively and may cause loss of
control and the accessory may burst .
To Attach Grinding Wheel
1 . Disconnect tool from power source .
2 . Be sure that Type B (Type 27) Grinding
Wheel Guard 3 is in place for grinding .
3 . Place Backing Flange 5 and Type 27 Grind-
ing Wheel 6 on the Spindle 4 . Make sure the
Backing Flange 5 locks into the base of the
Spindle 4 .
4 . Thread on the Lock Nut 11 and tighten the
Lock Nut 11 using the lock nut wrench,
while holding the Spindle Lock 7 .
TO REMOVE: Reverse procedure .
When Using Spin-On Wheels
Follow steps 1 & 2, then thread wheel direct-
ly onto Spindle 4 without using the supplied
flanges. Always make sure that the spin-on
wheel is tightened correctly with an open-end
wrench (not supplied) .
TO REMOVE: Reverse procedure .
All parts of a spin-on wheel must be within the
lip of Grinding Wheel Guard 3 (Fig . 5) . If spin-
on wheel is past the lip of the Grinding Wheel
Guard 3, do not use that wheel as it does not
fit on this grinder.
18
GWS11-450P_Final_20240417.indd 18
GWS11-450P_Final_20240417.indd 18
page heading
Assembly
Fig. 4
(7)
(4)
(4)
(6)
(11)
(6)
Fig. 5
Lip of Guard
(3)
(5)
Type 27 Spin-On
Grinding Wheel
(4)
(5)
(11)
Spin-On Wheel
4/17/2024 10:53:19 AM
4/17/2024 10:53:19 AM
Publicité
