Publicité
Type E (Diamond Surface Grinding
Wheel Guard) with Concrete Dust
Extraction Attachment for Surface
Grinding
A Type B (Type 27) grinding
wheel guard may not be
used for all tool operations. Do not discard
guard when not in use . Always reinstall wheel
guard when converting back to grinding opera-
tions .
Dust Extraction Attachment
is not a guard, do not use
with bonded abrasive wheels. Dust extraction
attachment may not protect operator in the
event of a wheel burst .
To Install Concrete Dust Extraction
Attachment
(Fig. 1, Fig. 10)
1 . Disconnect tool from power source .
2 . Position the Concrete Dust Extraction At-
tachment on the Guard Mounting Flange
with the dust port pointing away from the
tool body .
3 . Rotate the Concrete Dust Extraction Attach-
ment clockwise 90º until it clicks in place .
4 . Adjust the Concrete Dust Extraction Attach-
ment by depressing the Guard Release/Ad-
justment Lever 8 and rotate the Concrete
Dust Extraction Attachment to the desired
position .
5 . Allow the Guard Release/Adjustment Lever
8 to click in place .
6 . Place the Backing Flange 5 on the Spindle
4 .
7 . Place the diamond cup wheel onto the Spin-
dle 4, and align it with the Backing Flange 5 .
8 . Thread on the Lock Nut 11 and tighten the
Lock Nut 11 using the lock nut wrench,
while holding the Spindle Lock 7 .
When using spin on wheels, follow steps 1 - 5,
then thread the wheel directly onto the Spindle
4 without using the supplied flanges.
TO REMOVE: Reverse procedure .
22
GWS11-450P_Final_20240417.indd 22
GWS11-450P_Final_20240417.indd 22
Assembly
Fig. 10
(8) )
(7)
(4)
Wheel
Guard
Concrete
Extraction
Attachment
Spindle
Neck
4/17/2024 10:53:25 AM
4/17/2024 10:53:25 AM
Dust
Publicité
