Publicité
CREATE THE BUBBLES
1. Fill the Plastic Carbonating Bottle with cold water up to the fill line.
WARNING! Do not carbonate anything other than water. Other
liquids can contaminate and clog internal parts, potentially
resulting in excessive pressure, bottle failure during
carbonation and serious injury. Never carbonate after flavoring
has been added.
2. To insert the Plastic Carbonating Bottle, make sure that the Bottle
rest is angled forward. Please make sure you do not pull the
carbonating tube. WARNING! Never use a Sparkling Water Maker
with a broken carbonating tube. This can cause excessive
pressure, bottle failure and serious injury. Insert the Plastic
Carbonating Bottle neck into the Snap-Lock system. Push the Plastic
Carbonating Bottle up and back. The Snap-Lock will hold the
Plastic Carbonating Bottle.
3. To carbonate, Push down on the carbonating lever in short 1 second
presses; 3 presses for standard carbonation and 5 presses for high.
4. When the desired level of carbonation is achieved, gently pull the
Plastic Carbonating Bottle towards you until it reaches its fully
forward position. This will release the pressure in the Plastic
Carbonating Bottle and allow the Plastic Carbonating Bottle to be
released from the Snap-Lock.
WARNING! Do not remove Plastic Carbonating Bottle until after
hearing the sound of excess CO
Plastic Carbonating Bottle out of the Snap-Lock system. Always allow
the Sparkling Water Maker to release the Plastic Carbonating Bottle.
If the Plastic Carbonating Bottle does not immediately release from
the Snap-Lock system wait a few moments. If it still does not
release, then push the Plastic Carbonating Bottle back into the
vertical position and gently pull it towards you again. Attempting to
remove the Carbonating Bottle while it is still pressurized can
cause uncontrolled ejection of the Carbonating Bottle and may
result in serious injury.
CARE
SPARKLING WATER MAKER CARE
• Never use abrasive cleaners or sharp tools to clean. If needed, use a mild liquid dish soap and a soft
damp cloth to gently clean.
• Wipe spills to keep base dry.
• Do not place in water or wash in a dishwasher, doing so will seriously damage your Sparkling Water
Maker.
PLASTIC CARBONATING BOTTLE CARE
• For Plastic Carbonating Bottle which are not "dishwasher safe", to clean, rinse Plastic Carbonating
Bottlewith cold or lukewarm water. WARNING! Do not expose to heat above 50°C. Never wash or
rinse in hot water. Do not wash in dishwasher.
• For "dishwasher safe" Plastic Carbonating Bottle, to clean, either wash in dishwasher or rinse Plastic
Carbonating Bottle with cold or lukewarm water. WARNING! Do not expose to heat above 70°C.
being released. Never force the
2
1
2
Note: when inserted correctly, there is a small
gap between the bottom of the Carbonating
Bottle and the base. Do not carbonate if the
Carbonating Bottle is resting on the base, or
water will splash out.
3
Note: You may see small pieces of ice appear
in the water during carbonation of very cold
water. Any ice created will simply melt.
4
Publicité
