Publicité
SET UP
SODASTREAM
®/MD
Please note that the
SodaStream Art
is only
TM/MC
compatible with the C0
Quick
2
Connect Cylinder and is NOT
compatible with the
SodaStream
CO
Screw
®/MD
2
System Cylinder or other
cylinders.
INSTALLING THE CO
CYLINDER
1. Place the SodaStream Art
on a flat sturdy surface and pull open the back cover.
2. Remove seal and cap from the SodaStream CO
Connect Cylinder.
WARNING! Never insert or replace the CO
Connect Cylinder while a Carbonating Bottle is
installed in the Sparkling Water Maker. This can
cause the Carbonating Bottle to be ejected or burst.
3. Raise pink cylinder handle. Insert the CO
Cylinder in the back of the Sparkling Water Maker.
4. Lower cylinder Pink Handle.
5. Reinstall the back cover. Now you are ready to create the
bubbles.
CO
QUICK CONNECT CYLINDER
2
COMPATIBLE SODASTREAM
CO
QUICK CONNECT CYLINDER
2
QUICK CONNECT
2
Sparkling Water Maker
TM/MC
Quick
2
Quick
2
Quick Connect
2
NON-COMPATIBLE
®/MD
CO
SCREW SYSTEM CYLINDER
2
1
2
3
4
5
15
Publicité
