Publicité
OPERATING INSTRUCTIONS
3.2
Operating and status indicators
en
4
Mounting
5
Electrical installation
28
O P E R A T I N G I N S T R U C T I O N S | RAY26
Figure 1: SICK product ID
1
2
4
3
BluePilot blue: Indicator for contamination during run mode
1
Teach-in button
2
Yellow LED: status of received light beam
3
Green LED: supply voltage active
4
Mount the sensor and the reflector using suitable mounting brackets (see the SICK
range of accessories). Align the sensor and reflector with each other.
Note the sensor's maximum permissible tightening torque of 0.65Nm.
NOTE
RAY26P-XXXXX1 (MDO ≥ 1 MM), RAY26P-XXXXX3 (MDO ≥ 3 MM):
Recommended position of installation: between conveyor belts or conveyor rollers
Operation in standard I/O mode:
The sensors must be connected in a voltage-free state (U
tion must be observed, depending on the connection type:
–
Plug connection: note pin assignment
–
Cable: wire color
Only apply voltage/switch on the voltage supply (U
tions have been established.
= 0 V). The following informa‐
V
> 0 V) once all electrical connec‐
V
8022178.1P2U/2024-11-25 | SICK
Subject to change without notice
Publicité
