Table des Matières
Publicité
Micro SD card
anual
the battery
he contacts of the battery and the battery compartment, and then insert the
er Manual
-
Please only use the AC adapter and the battery provided. No part of this device
can be repaired by end-user. Contact your reseller should you need to replace
the AC adapter or the battery.
-
Talking time and standby time will depend on different conditions when using
the battery
the device, like signal intensity, working profiles, environment, temperature etc.
-
Do not throw the battery into fire or any severe environment with high
Charge with the provided travel adapter
temperature.
Connect the charger to an ac wall outlet.
Connect the plug from the charger to the jack on the bottom of the phone.
wer on/off
The battery indicator bar starts scrolling.
ss Power/End key for 2-3 seconds to switch on/off the phone.
If Not charging is displayed, wait for a while, disconnect the charger, plug it in
nlock password is required, enter the security code 1234.
again, and retry.
When the battery is fully charged, the bar stops scrolling. Disconnect the
charger from the phone and the AC outlet.
Charge with a PC data cable
Plug one end (micro-USB) of USB data cable into the phone USB jack.
Plug the other end of the USB cable into a USB port on a PC.
Note: Depending on the type of PC data cable you are using, it may take
some time before charging begins.
When the battery is fully charged (the battery icon is no longer moving),
unplug the USB cable from the device and then from the PC.
Make sure to charge the battery fully for the first time usage. Remove the data
AP and MMS users: Operator selection for first use
cable after charging.
e first time you are using this phone, or if you have changed your SIM card operator,
u will need to select your operator name before being able to send MMS (Multimedia
ssage) or connect to the internet (WAP service).
ect your operator so as to be able to send MMS message:
XF-manual-FR-v3.2.indd 22
Go to
MENU, MESSAGES, MESSAGE SETTINGS, MULTIMEDIA MESSAGE, DATA
carte mémoire (micro-SD). Mettez la
carte avec les contacts métalliques
vers le bas et refermez la petite porte
afin que celle-ci soit couchée sur la
carte SD et glissez la petite porte mé-
tallique vers le bas. Une carte mémoire
donne un espace supplémentaire pour
des photos, des vidéos et internet.
11
4. Placez l'accu en poussant les
contacts dorés de l'accu contre les
contacts dorés du téléphone et puis
poussez l'accu dans le téléphone.
5. Replacez la cache arrière sur le
téléphone. Serrez les vis fermement
pour vous assurer que le téléphone
est étanche à l'eau et à la poussière
6. Allumez le téléphone (appuyez
pendant 3 secondes sur la touche
allume/éteint/fin).
12
20-8-2015 16:19:23
Publicité
Table des Matières
