Storage And Transport; Troubleshooting - Klauke mini EK 15/50 Mode D'emploi

Instruction Manual Crimping Tool
EK 15/50, EK 15/50G, EK 35/4
Do not use the cord to transport the charging unit or to pull the plug out of a wall socket with force (pic. 34). Do not
insert strange parts into the ducts of the charging unit. Pull the plug of the charging unit after charging (pic. 27). Do
not disassemble the charging unit or battery (pic. 33).
The charging of the batteries must only be made with generic chargers. The mini battery can be charged with all
Klauke chargers.
Attention
Do not place the battery in your pocket or in your toolbox if there are any conductive materials in it such as
coins, keys, tools or other metallic parts.
In order to safeguard a safe and proper performance of the charging unit the repair and service of the unit should be
made through our Service Center.

4.6 Storage and transport

In order to protect the tool against damages it has to be cleaned carefully after every use and be put into the trans-
portation case which has to be closed safely. Into this plastic carrying case you accommodate besides the crimping
tool the charging unit, 12 sets of crimping dies and the instruction manual.
5.

Troubleshooting

a.) Constant fl ashing of the light diode display (pic. 1, 6) at the end of a pressing cycle.
Service due. Please send the tool to your nearst Authorized Service Center (ASC). (Pls. See also chapter 4.3 for
more information)
b.) The tool loses oil.
Return the tool to the manufacturer. Do not open it and damage the seals of the tool.
c.) The pressing tool does not reach the fi nal operating pressure.
Stop the crimping process. Actuate the retract slide (pic. 1, 3) and the operating switch continuously and simul-
taneously for about 10 sec. Is the malfunction not be eliminated by this attempt the tool has to be returned to the
manufacturer.
HE.9446_L © 12/10 12
GB