Mounting Instructions; Service And Maintenance Instructions - Klauke mini EK 15/50 Mode D'emploi

Instruction Manual Crimping Tool
EK 15/50, EK 15/50G, EK 35/4

4.3 Mounting instructions

If other applications that exceeds those mentioned in table 2 must be performed with this tool it is necessary to con-
tact the manufacturer.
Despite the same code numbers the compression width for copper and aluminium cable lugs and connectors is dif-
ferent. Besides the marking of the dies the plating is different too.
Attention
Even if the code number is identical only those dies should be used which are suitable for the material.
Please read the assembly instructions in Chapter „Technical attachment" of our general catalogue.
4.4 Service and maintenance instruction
For every day service the tool has to be cleaned and dried after each use. The battery cartridge and the charging unit
have to be protected against humidity and dust.
Attention
Maintain power tools thoroughly. Check for functionality or jamming of moving parts, breakage of parts and
any other condition that may affect the power tools operation.
The electric-hydraulic unit is equipped with a controller enabling the user to see when the next service is due by
fl ashing for 20 sec. at the end of a working cycle. When the next service is due after 10.000 cycles the unit must be
returned to an authorised service center (ASC). During this service worn out parts will be exchanged, safety relevant
components checked and possibly replaced pre cautiously. This provision serves your safety and avoids failures
through fatigue. Within the determined use of the tool only the dies are permitted to be changed by the customers.
Attention
Do not damage the seals of the tool
Attention
Have the power tool repaired by a qualifi ed expert or by a Klauke ASC before use.
HE.9446_L © 12/10 10
GB