Service And Maintenance Instructions; Troubleshooting - Klauke mini+ EKM 60/22-L Mode D'emploi

Instruction Manual Crimping tool
EKM 60/22-L EKM 60/22W-L
4.4 Service and maintenance instruction
For every day service the unit has to be cleaned and dried after each use. The battery cartridge and the charging unit
have to be protected against humidity and dust.
The electric-hydraulic unit is equipped with a controller enabling the user to see when the next service is due by fl as-
hing for 20 sec. at the end of a working cycle. When the next service is due the unit must be returned to an authorised
service center (ASC). Failure to observe this request results in loosing the Warranty. Preventive maintenance serves
your safety. Within the determined use of the tool only the dies are permitted to be changed by the customers.
Attention
Do not damage the seals of the tool. If the seals are damaged the warranty is invalidated.
5.

Troubleshooting

a.) Constant fl ashing/indicating of the red LED (pic 1.3) or the occurence of an acustical warning signal.
 see tab. 1. If the failure can not be resolved through the action recommended in tab. 1 return the tool to the
nearest service center (ASC).
b.) The tool loses oil.
 Return the unit to the manufacturer. Do not open it and damage the seal of the tool.
c.) The red LED fl ashes 3x and simultaneously 3 acoustic warning signals occure (see tab. 1).
 Serious fault! If this fault occures repeatedly return the unit to an Autorized Service Center (ASC). Do not open
it and damage the seal of the tool.
In case of a one time occurence the connector has to be pressed a second time.
HE.14051_B © 11/2010 7
GB