Description Of The Components; Brief Description Of The Important Features Of The Unit - Klauke mini EK 15/50 Mode D'emploi

Instruction Manual Crimping Tool
EK 15/50, EK 15/50G, EK 35/4
3. Description of the battery operated electro-hydraulic crimping tool

3.1 Description of the components

The crimping tool type EK15/50, EK15/50G and EK35/4 is a hand held tool and consists of the following compo-
nents:
Table 1 (see pictures 1, 3 and 5)
Pos. Bezeichnung
1 Dies
2 Crimping head
3 Retract slide
4 battery lock
5 Battery (RAM2)
6 LED
7 Trigger
8 Latch

3.2 Brief description of the important features of the unit

The hydraulic unit incorporates an automatic retraction which returns the piston into its starting position when the
maximum force is reached.
The unit is equipped with a special brake which stops the forward motion of the piston/dies when the trigger
(pic. 3, 7) is released.
The tool incorporates an LED display to indicate the battery capacity and service intervals.
The EK15/50 and EK15/50G have a pre-crimping device which clamps the connectors fi rst before actually crimping
it. This allows the installer to interrupt the crimping cycle to re-position the connector, respectively make necessary
corrections.
Enable wide spread Klauke dies, which are used in the following tools:
The crimping head can be smoothly turned by 345° around the longitudinal axis in order to gain better access to
tight corners and other diffi cult working areas. (pic. 17+29)
The tool is very light weight and provides a good handling through an ergonomic design.
HE.9446_L © 12/10
Funktion
Interchangeable crimping dies with multiple crimping geometries
Working unit to accommodate the crimping dies
Bar to open the crimping dies in case of an error or emergency
Slide to unlock the battery
Rechargeable NiMH battery 9.6V
Battery charge control and indication of Service Intervals
Actuator to start the crimping cycle
To open the crimping head
13 kN range: K50 + K51 and for the
35 kN range: HK4
3
GB