Mounting Instructions; Service And Maintenance Instructions; Troubleshooting - Klauke mini+ Mode D'emploi

Instruction Manual
EK 50/5-L
The tool is not designed for continued crimping operations. After a sequence of approximately 30-40 completed
crimps you have to make a break of 15 min. to give the tool time to cool down.
Attention
Too intensive use can cause heat damages for the tool
Attention
During the operation of electric engines sparks can occur which might ignite highly infl ammable or explosi-
ve liquids and materials
Attention
Electric-hydraulic crimping tools should not be operated in pouring rain or under water.

4.3 Mounting instructions

Please read the assembly instructions in our general catalogue.
Attention
Even if the code number is identical only those dies should be used which are suitable for the material.
4.4 Service and maintenance instruction
Within the determined use of the tool only the dies are permitted to be changed by the customers.
Attention
Do not damage the seals of the tool. If the seals are damaged the warranty is invalidated.
5.

Troubleshooting

a.) Constant fl ashing/indicating of the red LED (pic 1.3) or the occurence of an acustical warning signal.
see table 1. If the failure can not be resolved through the action recommended in table 1 return the tool to the
nearest service center (ASC).
b.) The tool loses oil.
Return the unit to the manufacturer. Do not open it and damage the seal of the tool.
HE.13435_B © 02/2010 6
GB