Publicité
Operating Safe with a Personal Code
3
The process for locking the door using the personal code and changing the
personal code are the same.
To lock the door:
Push and hold the door in the closed position.
1
Input any four-digit personal code.
2
Press "A" on the keypad.
3
The display will show "CLOSE", immediately followed by "CLOSED"
4
indicating that the bolts are extended and the door is locked.
The four-digit personal code will be displayed for two (2) seconds.
5
To unlock the door:
Input the current four digit code.
1
The display will show "OPEN".
2
When the door is successfully unlocked, the display will show "OPENED".
3
If the code is incorrect, the display will show "E-CODE".
4
The spring-loading feature of the safe will enable the door to
5
open automatically.
IMPORTANT
"B" is a deletion key. Pressing it once will delete one character
on the reader.
"HOLD
Three (3) repeated attempts to open the door using an
+ DIGIT" invalid code will result in the safe being automatically
locked for 15 minutes. The safe will not respond to any key
and the display will read "HOLD + DIGIT" where "DIGIT" is
the holding time. After 15 minutes, the safe will return to
normal operation.
"LO-BAT" In a low voltage condition, the display will show "LO-BAT"
(in both a door open or door closed state).
"E-RUN" An "E-RUN" message on the display during a closed door or
open door state indicates the door is not or will not lock. If
this situation occurs, (1) unlock the unit; (2) hold the door
closed and attempt to re-lock it.
4
Operating Safe with a Master Override Key
4
(for emergency opening)
In an emergency situation (i.e. the magnetic stripped card is not available and/
or the personal code is unknown), the safe can be opened using the master
override key.
Unscrew and remove the key lock cap on the front door of the unit.
1
For proper installation, the notch in the master override key must be at the
2
top edge.
Insert the key to unlock the safe.
3
Reprogramming Safe Lock After Override
5
Key Use
Leave override key in the unlocked position.
1
Press the "B" button.
2
The safe lock will beep twice.
3
Close the door; lock the door using the override key and remove key
4
from door.
Punch in the code "1234" to open the safe door. The unit has now been
5
reprogrammed and is ready for use with any four digit code or magnetic
stripped card.
Key lock cap
5
Publicité
