Publicité
Getting started
Thank you for purchasing a SentrySafe Product. SentrySafe is the world leader in
fire/water resistant and security storage. This guide describes how to easily set-up
the product.
Contents Include:
- Security Safe (1)
- Bolt-down Screws (4)
- Auxiliary Remote Battery Pack (1)
Requires 4 "AA" Batteries (Not Included); Voltage 6VDC:
- Master Override Keys (2)
- Operator Manual
Instructions
The SentrySafe Security Safe can be operated with (1) a magnetic stripped card
(example: major credit card), (2) a personal four digit code, or (3) the master
override key provided with the unit.
The method used to operate (lock and unlock) the safe must be the same
unless using a master override key to unlock safe.
Registration:
To be eligible for warranty coverage, the original purchaser must register
the product online at www.sentrysafe.com or complete and return the
enclosed registration card to SentrySafe
2
Installing the Batteries
1
With the door open, remove the battery compartment cover located on
1
the inside of the door by sliding the cover from right to left.
Install four (4) AA size batteries (not provided). Note the polarity (+/-)
2
markings in the battery compartment to ensure proper installation.
Reinstall the battery compartment cover.
2
Operating Safe with a Magnetic
2
Stripped Card
The card reader in the safe can be operated with a magnetic stripped card (i.e.
most major credit cards).
To lock the door:
Push and hold the door in the closed position.
1
Press "B" on the keypad. The display will show "CARD".
2
Swipe the card from right to left.
3
The display will show "CLOSE", immediately followed by "CLOSED"
4
indicating that the bolts are extended and the door is locked.
To unlock the door:
Press "B" on the keypad.
1
The display will show "CARD".
2
Swipe the card from right to left.
3
The display will show "OPEN", immediately followed by "OPENED"
4
indicating that the bolts are retracted into the door.
The spring-loading feature of the safe will enable the door to
5
open automatically.
IMPORTANT
The card must be swiped firmly and evenly from right to left.
"AGAIN" If the card is swiped from left to right or at a pace that is
too fast or too slow, the reader will display "AGAIN" for
two seconds, then "CARD" indicating that the card must be
swiped again.
"E-CARD" The card used to access the safe must be the same as the
card used to close the safe. Otherwise, the display will
show "E-CARD".
3
Publicité
