Publicité
Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.
Explanation of the symbols used (see Fig. 10)
1. Danger! - Read the operating instructions to
reduce the risk of injury.
2. Caution! Wear ear-muff s. The impact of noi-
se can cause damage to hearing.
3. Caution! Wear a breathing mask. Dust
which is injurious to health can be generated
when working on wood and other materials.
Never use the device to work on any materi-
als containing asbestos!
4. Caution! Wear safety goggles. Sparks ge-
nerated during working or splinters, chips and
dust emitted by the device can cause loss of
sight.
5. Used to indicate electrical devices which
have a double insulated housing and are
therefore protection class II compliant.
6. Hazard statement: Risk of injury and risk of
damage to the device.
7. Always use both hands when working.
1. Safety regulations
The corresponding safety information can be
found in the enclosed booklet.
Warning!
Read all the safety information, instructions,
illustrations and technical data provided on
or with this power tool. Failure to adhere to the
following instructions may result in electric shock,
fi re and/or serious injury.
Keep all the safety information and instruc-
tions in a safe place for future use.
This equipment is not allowed
to be used by children. Children
should be supervised so
that they do not play with the
Anl_CC_PO_1100_150_CE_SPK13.indb 13
Anl_CC_PO_1100_150_CE_SPK13.indb 13
GB
equipment. Children are not
allowed to carry out the cleaning
or maintenance. This equipment
is not allowed to be used by
people with limited physical,
sensory or mental capacities
or by those with insuffi cient
knowledge or experience unless
they are supervised or instructed
by a person who is responsible
for them.
2. Layout and items supplied
2.1 Layout (Fig. 1)
1. Spindle lock
2. Additional handle
3. On/Off switch
4. Speed control
5. Rear handle
6. Power cable
7. Polishing / sanding disk
8. Speed indicator
2.2 Items supplied and unpacking (Fig. 2)
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any pa-
ckaging and/or transportation braces
(if available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
- 13 -
19.09.2024 15:12:42
19.09.2024 15:12:42
Publicité
