Télécharger Imprimer la page

ATH-Heinl ATH Frame Lift 30FZ Mode D'emploi page 84

Publicité

3.2
Basic notes
The machine may only be operated independently by persons who have reached the age of 18, who have
been instructed in the operation of the machine and who have proven their qualification to the employer.
They must be expressly authorized by the employer to operate the machine. The order to operate the
machine must be given in writing.
The machine may only be used for its intended purpose.
Always use specified material for assembly and operation.
Before assembly or disassembly, check all components; they must not show any signs of damage.
If necessary, follow the manufacturer's special instructions for the assembly or disassembly of vehicle-
specific work.
An important part of the guarantee / warranty is the fulfillment of the maintenance schedule. In particular, the
cleanliness, corrosion protection, control if necessary immediate repair of damage.
Always watch out for hazards during operation. As soon as hazards occur, immediately disconnect the
system from all energy sources (electricity, etc.). Then contact your dealer.
All warning signs must always be clearly legible. If they are damaged, they must be replaced immediately.
Danger
Pay attention to possible shearing points on the machine.
Caution
During operation, the noise level can reach 85dB (A), so the operator should take
appropriate protective measures.
Danger
Moving parts of the machine can catch loose clothing, long hair or jewelry.
3.3
Operating the lift
The product is intended for lifting vehicles. The corresponding
observed.
Preparation
Read all
"Safety instructions"
Lower the lift completely.
Position the vehicle in the center between the scissors and pay attention to the load distribution.
Place the ZENTRAL rubber plates under the designated vehicle support points.
® Copyright ATH-Heinl GmbH & Co. KG / All rights reserved / Misprints and technical changes reserved
84
carefully before operating the lift.
Release date: 27.09.2024 / Product manufacturer ATH-Heinl GmbH & Co. KG
"Technical data"
of the lifting platform must be

Publicité

loading