Publicité
IMPORTANT
The active load "Manganic sand" is based on Manganese dioxide.
This product is classified as harmful by ingestion and inhalation. The necessary protective measures
must therefore be taken when loading,
minimally gloves, goggles, mask with P3 filter (single use or reusable).
Remove affected clothing and wash exposed skin with mild soap and water, then rinse with warm water.
An SDS is available on request from our branches. To limit dust dispersion, put water in the filter body
when loading. Once the load is in place, backwash the load at a high flow rate for approximately 30 minutes
(until the fines visible to the naked eye are removed).
OPTIONS
BYPASS SUPPRESSION VALVE
A kit must be provided if there is a need for a ban on unfiltered water leaving the filter during washing.
Its code is 125301884
It consists of fitting a hydraulic valve to the outlet side of the bypass module and controlling this valve
in parallel with the lower pilot control.
36
BWT PURITY PRO XL Technical Manual - code 125502287 - Rev 1 - 27/09/2021
Publicité
