Trixie TR1250 Mode D'emploi page 12

shown in Figure D to prevent oil from getting into the motor. Place a few drops of the clipper
oil on the front and side of the cutter blades (Figure C). Wipe excess oil off blades with a soft
dry cloth. Spray lubricants contain insufficient oil for good lubrication, but are an excellent
clipper blade coolant. Always replace broken or nicked blades to prevent injury. You can
clean the excess hair from your blades by using a small brush or worn out toothbrush. To
clean the blades we suggest to immerse the blades only into a shallow pan of the clipper
oil, while the clipper is running. Any excess hair and dirt that has accumulated between the
blades should come out. After cleaning, turn your clipper off and dry blades with a dry cloth
and start clipping again.
Replacement/Removal of the blade set
To remove the blades, first unplug the clipper from the electrical outlet. Turn the clipper up-
side down so that the blade teeth are pointing down. You may want to place the clipper on a
flat surface to do this. Unscrew the screws on the blades. Remove the blades. To replace the
blades, put the smaller, upper blade back into position (Figure F). Line up the screw holes in
the bottom blade with the two holes in the clipper housing, and replace the screws. Do not
tighten down the screws completely. Turn the clipper over and align the lower blade so the
teeth on both blades are parallel, but with the lower blade's teeth slightly above the upper
blade's teeth. Failure to do this may result in nipping the skin when cutting the hair.
Blade und Clipper/Trimmer Repair Service
When the blades of the clipper/trimmer TR1250 become dull after repeated use, it is advised
to purchase a new set of blades available through your supplier. Some blade sets can be
resharpened - contact your supplier or the TRIXIE Heimtierbedarf GmbH & Co. KG for in-
formation on resharpening. If you wish your clipper/trimmer to be serviced as well, contact
your supplier.
Disposal in EU countries
Follow the appropriate laws and regulations for the disposal of the device. Information for
the disposal of electric and electronic devices in the European Union: In the European Union
the disposal of electric devices is regulated nationally, based on the EU-guideline 2012/19/
EU for Waste Electrical or Electronic Equipment (WEEE). Accordingly, this device may not be
disposed of through the community or domestic waste collection services. This
device will be accepted at community collection points or recycling yards free of
charge. The product packaging consists of recyclable materials. Dispose of these
properly to protect the environment and ensure it can be reused or recycled.
12