Power Adjustment; Checking The Blades - Trixie TR1250 Mode D'emploi

Power Adjustment

Your clipper TR1250 has been adjusted to line voltage at the factory. However, because of
voltage variations, it may be necessary to adjust the power setting for your area. If the pow-
er adjustment is off, you will usually notice a "clatter" when the clipper is on or introduced
into the hair. (It is normal for your clipper to"clatter" for an instant when initially turned on).
To adjust your clipper
1. Oil the blades (Figure C).
2. The power screw is located in the lower part of the housing opposite the switch (Figure D).
3. Turn your clipper on.
4. Using a standard screwdriver that fits the slot, turn the power screw clockwise until the
clipper clatters continuously. Then turn the screw counterclockwise carefully until the
clatter ceases.
5. Your clipper is now adjusted to its optimum power setting.
Clipper blade adjustment
The clipper blade set is easy to adjust. From coarse to fine cuts, all that's needed is a flick of
the adjustment lever with your thumb. In the upright position, blades are set for the finest,
or shortest cuts (Figure E).
Servicing of the clipper
Cleaning and user maintenance shall not be made by children without supervision. The
internal mechanism of your clipper has been permanently lubricated at the factory. Other
than the recommended maintenance described in this manual, no other maintenance
should be performed, except by TRIXIE Heimtierbedarf GmbH & Co. KG. If the supply cord
is damaged it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.

Checking the blades

Due to the high speed nature of the clipper TR1250, please check for blade heat often,
especially on close cutting blades. If you have a detachable blade unit, you can change your
blade in order to maintain a comfortable temperature; using multiple blades of the same
size is popular among groomers.
Care and servicing of the clipper blades
Blades should be oiled before, during, and after each use. If your clipper blades leave streaks
or slow down, it's a sure sign blades need oil. The clipper should be held in the position
Clipper Set TR1250 · Operating instructions
23870
Item no.
11