Cleaning And Maintenance - Stokke Tripp Trapp Notice D'utilisation

READ CAREFULLY BEFORE ASSEMBLING
YOUR TRIPP TRAPP® CHAIR.
On the fold out page of this user guide you will find
pictures that describe the assembly of your Tripp Trapp®
chair and Tripp Trapp® Baby Set. The Baby Set should only
be used with the seat plate in the first groove from top
of the chair.
Parts
10 Metal screws • 6 Metal nuts • 1 Allen Key • 2 Curved backrests
2 Metal cross bars • 1 Wooden base cross bar • 1 Seat • 1 Foot-
rest • 2 Legs
1. Attach the base cross bar to the legs (grooves face
inside). Important to insert the shallow end of nut first!
2. Insert screws and tighten firmly.
3. Attach the two metal crossbars and tighten loosely
4. Attach the two curved back rests. Insert metal nut with
shallow end first and tighten loosely. NOTE: Backrest
with strap goes into bottom slots.
5. Slide seat and footrest into slots, with straight edge
facing forward. Make sure the height and depth of the
seat and footrest suit the size of your child (see instruc
tions for seat and footrest adjustments in this user
guide).
6. Place the chair on a level surface. Finally tighten
all screws firmly in the order given.
SEAT AND FOOTREST ADJUSTMENT
It is important to adjust the depth and height of the seat
and footrest to fit the size of your child. See illustrations
on the fold out page, and description below. The settings
of the seat and footrest should be checked as the child
grows – at least once a year!
The seat plate and the footrest must be supported by
the full length of the grooves on the sides (not half way
supported).
Seat placement
Height – The seat is set at the correct height when your
child's elbows are level with the table top.
Depth – For correct depth of the seat, position the child's
back against the backrest with the seat supporting ¾
of the thighs. For the child's best comfort it is important
that the seat depth is not too deep. Leave comfortable
space between the front edge of the seat and back of the
child's knee.
For a child 6-8 months it may amaze you how small seat
they actually need! The seat plate should not protrude
more than 1½-2" (4-5cm) in front of the chair side legs.
Footrest placement
Height – The footrest is set at the correct height when
the sole of the child's foot can rest flat on the footrest,
while the thighs are touching the seat.
Depth – Make sure the forward edge of the footrest
NEVER exceeds the front tip of the chair legs at floor level
Accessories
Tripp Trapp® Cushion
Comes in several colours
and designs. It fits your Tripp
Trapp® chair both with and
without Tripp Trapp® Baby
Set.
Tripp Trapp® Babyset
Babyset intended for
children from 6 months
and up to 36 months.
Table of age and approxmate adjustment
This table is a rough guide for the height adjustment of
seat and footrest according to the age of you child. Child
differ in size according to age, so always make sure that
your child is seated correctly according to the instruc-
tions given in this user guide.
AGE SEAT
6 months 1
1 1/2 year 2
3 year 2
7 year 3
10 year 4
Teen/ Adult n.a.
*) Use footrest as seat. Therefore seat is not applicable.
RESTRAINT SYSTEM OPERATION
Always use the restraint system when the seat is in the
1st, 2nd or 3rd grooves from the top. Place child in seat.
Pull each arm through the loop formed by the shoulder
and waist strap, and place in child's lap. Crotch strap
comes up between child's legs. Attach each shoulder
strap to the crotch strap. Adjust length of shoulder, waist
and crotch strap to restrain child in seat. Crotch strap
length should be adjusted so that connector is at waist
height.
The restraint system can be removed when your child has
reached the age of 36 months AND is able to sit safely
on TRIPP TRAPP®. Use a tool to remove the clip under the
seat plate to detach the crotch strap. Use a screwdriver to
detach the rest of the harness from the backrest.
Product information: The chair is made of cultivated
beech wood. The varnish contains no harmful sub-
stances, and the liberation of formaldehyde from the
varnish complies with E1 requirements.
Safety approval: Tripp Trapp® chair complies with AS
4684:2009 in combination with Tripp Trapp® Baby Set™/
Tripp Trapp® Newborn Set™ and ASTM F404-14.

CLEANING AND MAINTENANCE

Wipe with a clean damp cloth, wipe off excess of water
with a dry cloth. Moisture will crack stain. We do not rec-
ommend the use of any detergent or micro fibre cloth.
Colours may change if the chair is exposed to the sun.
US/CA
FOOTREST
5
6
8
11
14
4-5*
3