sylvac S Dial WORK Smart Mode D'emploi page 11

5. Inputting tolerance limits
To input or modify the tolerance limits, toL On mode should be selected, followed by a short press on
Note :
- For measuring internal dimensions, the red and yellow indicators can be switched over by reversing the order in which
the tolerance limits are input (lower limit > upper limit).
- It is possible to input different tolerances on REF1 and REF2.
SET
MODE
— Input the lower tolerance limit
MODE
— Input the upper tolerance limit
MODE
next digit
SET
11
:
MODE
0...9 save TOL
MODE
E