Publicité
battery; avoid contact. If con-
tact accidentally occurs, flush
with water. If liquid contacts
eyes, additionally seek medical
help. Liquid ejected from the battery
may cause irritation or burns.
e) Do not use a battery pack or
tool that is damaged or modi-
fied. Damaged or modified batteries
may exhibit unpredictable behaviour
resulting in fire, explosion or risk of in-
jury.
f) Do not expose a battery pack
or tool to fire or excessive tem-
perature. Exposure to fire or temper-
ature above 130 °C may cause explo-
sion.
g) Follow all charging instructions
and do not charge the battery
pack or tool outside the tem-
perature range specified in the
instructions. Charging improperly
or at temperatures outside the spe-
cified range may damage the battery
and increase the risk of fire.
6. SERVICE
a) Have your power tool serviced
by a qualified repair person us-
ing only identical replacement
parts. This will ensure that the safety
of the power tool is maintained.
b) Never service damaged bat-
tery packs. Service of battery packs
should only be performed by the man-
ufacturer or authorized service pro-
viders.
Hammer Safety Warnings
Safety instructions for all
operations
• Wear ear protectors. Exposure to
noise can cause hearing loss.
• Use the auxiliary handle(s), if
supplied with the tool. Loss of
control can cause personal injury.
• Hold the power tool by insu-
lated gripping surfaces, when
performing an operation where
the cutting accessory may con-
tact hidden wiring. Cutting access-
ory contacting a "live" wire may make
exposed metal parts of the power tool
"live" and could give the operator an
electric shock.
Safety information for using long
drills with hammer drills
• Always begin drilling at a low
speed and when the drilling
tool is in contact with the work-
piece. Higher speeds can cause the
drill to bend slightly when rotating
freely without contact with the work-
piece and can also cause injury.
• Do not apply excessive pres-
sure to the drill. Only apply
pressure lengthwise along the
drill. Drills can bend and break or
cause a loss in control, thus resulting in
injuries.
Additional safety instructions
• Secure the workpiece. A work-
piece clamped with clamping devices
or in a vice is held more secure than by
hand.
• Switch the power tool off imme-
diately if the application tool
becomes blocked. Be prepared
for high torque reactions which
cause kickback. The application
tool becomes blocked when it becomes
jammed in the workpiece or when the
power tool becomes overloaded.
• Always wait until the power
tool has come to a complete
stop before placing it down. The
GB
MT
31
Publicité
