Publicité
3. Before commissioning
Remove all packaging material and transport
safety devices from the appliance.
Unwind the supply cable fully from the cable
clamp 6 .
3.1 Assembling the rollers
Place the oil-filled radiator with its lower side
upwards on a clean, scratch-resistant base.
Attach respectively 2 rollers 5 to
each outer recess in the retaining
plates 3 and 4 . Use the pre-as-
sembled cap nuts for this purpose.
Now unscrew the wing nuts
from the retaining brackets
Now position a retaining bracket
on the heating fin (see figure
11
no. I)
Note: Note here that the front retaining plate 4
must be fitted between the 1st and 2nd ribs and
the rear retaining plate 3 between the last two
heating ribs. This is the only means to ensure correct
positioning.
Then push the retaining bracket
less side threadless side into one of the two inner
recesses of the retaining plates 3 / 4 with rollers
3 (see figure no. II).
Both threaded fittings for the holders
finally protrude through the recesses on the
retaining 3 / 4 plate (see figure no. III).
Now screw the wing nut
retaining bracket
11
Repeat the entire procedure from the Chapter for
the second retaining plate 3 / 4 with rollers 5 .
ATTENTION: Only operate the appliance with
assembled rollers 5 and retaining plates 3 / 4 .
12
GB/IE/NI/CY/MT
.
11
with the thread-
11
must
11
back onto the
12
(see figure no. IV).
3.2 Setting up the appliance
For safe, fault-free operation of the appliance, its
location must meet the following prerequisites:
The base must be firm, flat and level.
Minimum clearance from the casing of 1 m at
the side, 1 m at the top, 1 m at the back and 1 m
at the front must be adhered to.
Do not place the appliance in a hot, wet or very
wet surroundings or in the vicinity of combusti-
ble material.
The mains socket must be easily accessible,
enabling easy removal of the supply cable if
necessary.
Temperature range: 0 to +40 °C
Humidity (no condensation): 5–75 %
Note: During initial use, slight odours may arise in
12
the short-term.
4. Commissioning
4.1 Switching the appliance on
Ensure that the heating level switch 8 is set to
"0" and the temperature control 9 points to " ".
Then, connect the oil-filled radiator to an earthed
socket protected by an FI circuit breaker.
Then, switch the appliance on by rotating the
temperature controller 9 clockwise until it clicks
audibly. The red indicator lamp 7 lights up.
Move the heat level switch 8 to the desired
position (1, 2 or 3). The following applies:
0
Off position
1
Heating level
1:
If the heating level switch
8 is in this position,
the oil-filled radiator is
switched off.
If the heating level switch
8 is in this position,
the oil-filled radiator
provides a heat output
of 600 W.
Publicité
