Husqvarna DM 220 Manuel D'utilisation page 16

2. Push the Reset button to set the specified drill angle.
This is now the new zero level for correctly aligned
drill angle.
3. To set the drill angle to drill in a horizontal angle,
push and hold the Reset button for 3 seconds. The
drill angle is also set to drill in a horizontal angle
when the product is disconnected from the mains
socket for a longer time.
To start the product
WARNING:
can rotate freely. The drill bit starts to rotate
when the motor starts.
WARNING:
started on the work day, do a check of the
PRCD. Refer to
1. Connect the power plug of the product to a power
outlet.
16
Make sure that the drill bit
The first time the product is
PRCD on page 9 .
2. Push the "RESET" button on the PRCD.
3. To set the operation speed, turn the drill spindle and
at the same time move the gear selector. Set the
gear selector in the correct position for the operation.
4. For wet drilling, connect the water system and the
open the water system. Refer to
product for wet drilling on page 13 .
5. For dry drilling, attach the dust extractor to the
product and start the dust extractor. Refer to
prepare the product for dry drilling on page 12 .
To prepare the
To
1794 - 003 - 08.03.2024