Husqvarna DM 220 Manuel D'utilisation page 14

6. Connect the slurry collector/wet dust extractor to the
connection of the slurry ring.
7. Put the slurry ring on the drill spindle (C).
C
8. Install the drill bit to the drill spindle (D).
9. Start the slurry collector/wet dust extractor.
14
D
10. Lift the drill bit to the ceiling. Attach the slurry ring to
the ceiling.
To decrease the temperature of the
motor
• Operate the product with no load for 2 minutes to
decrease the temperature of the motor.
To change gear
CAUTION:
motor decreases in speed or stops. Do not
use force to change gear.
• Use the applicable speed for the drill bit diameter.
Refer to the rating plate on the product or
data on page 23 .
• Turn the drill spindle and at the same time turn the
gear selector to change gear.
To drill a hole at a specified angle
The product has an electronic level indicator that senses
the angle of the product. The electronic level indicator
helps the operator to drill in the specified angle.
Change gear only when the
Technical
1794 - 003 - 08.03.2024