Husqvarna DM 220 Manuel D'utilisation page 11

3. Make sure that the nominal voltage and current in
the power outlet is the same as the voltage and
current of the product.
4. Make sure that the PRCD is started. Refer to
on page 9 and To examine the PRCD on page 9 .
5. Make sure that the work area is clean and bright.
6. Use personal protective equipment. Refer to
Personal protective equipment on page 8 .
7. Make sure that the product is installed correctly. The
drill bit must be attached correctly.
8. If you use the product with a drill stand, read the
operator's manual for the drill stand carefully and
make sure that you understand the instructions.
Make sure that the product is attached correctly.
To prepare the product for operation with
Refer to
a drill stand on page 11 .
9. If you do not use a drill stand, the auxiliary handle
must be connected and fully tightened. Refer to
set the auxiliary handle in an applicable position on
page 12 .
10. When you operate the product dry, use a dust
To prepare the product for dry
extractor. Refer to
drilling on page 12 .
11. When you operate the product wet, make sure that
the water system is not damaged and use the water
To prepare the product for wet
connector. Refer to
drilling on page 13 .
12. When you do inverted drilling, make sure that you
comply to the applicable instructions. Refer to
prepare the product for inverted drilling on page 13 .
To use the product with a drill stand
CAUTION:
this section carefully.
CAUTION:
for the drill stand carefully.
• Always use a drill stand if you stand on a scaffold
when you drill.
• Make sure that the drill stand is correctly attached.
• Make sure that the product is correctly attached in
the drill stand. Refer to
operation with a drill stand on page 11 .
• Use only with approved Husqvarna drill stands.
Accessories on page 24 .
Refer to
• Attach the trigger lock bracket. Refer to
trigger lock bracket to the product on page 11 .
1794 - 003 - 08.03.2024
PRCD
To
If you use a drill stand, read
Read the operator's manual
To prepare the product for
To attach the
To prepare the product for operation with a
drill stand
1. Loosen the screw (A).
To
2. Remove the protective cover (B).
3. To attach the product to a drill stand, refer to the
manual for the drill stand. Use only with approved
Husqvarna drill stands. Refer to
page 24 .
To attach the trigger lock bracket to the
product
The trigger lock bracket must only be used when you
use a drill stand. The trigger lock bracket pushes and
holds the power switch to start position.
1. Attach the product to a drill stand. Refer to
prepare the product for operation with a drill stand
on page 11 .
2. Turn the knob (A) clockwise.
A
3. Install the trigger lock bracket to the product.
B A
Accessories on
To
11