Husqvarna DM 220 Manuel D'utilisation page 12

4. Turn the knob (B) counterclockwise to push and hold
the power switch to start position.
B
To use the product handheld
Do not do handheld drilling in first gear (A).
WARNING:
in first gear. The product has a strong torque
that can result in injury if the drill bit stops to
move freely.
1. Install a drill bit with a maximum diameter of 80 mm.
The larger the drill bit, the more dangerous reaction
if the drill stops to move freely.
2. Lock the auxiliary handle tightly in position before
you start to drill. Refer to
in an applicable position on page 12 .
3. During operation, keep a stable position with you
feet on the ground.
WARNING:
ladder. If the drill bit stops suddenly, the
strong torque can cause you to fall.
4. Change the gear to 2 or 3. Refer to
on page 14 .
12
A
Do not do handheld drilling
To set the auxiliary handle
Do not drill from a
To change gear
To set the auxiliary handle in an
applicable position
1. Turn the handle counterclockwise to release it.
2. Move the handle around the spindle shaft to an
applicable operation position.
3. Turn the handle clockwise to lock it. Tighten fully.
To prepare the product for dry drilling
WARNING:
protection. Do not breathe the dangerous
dust.
WARNING:
vacuum cleaner. Use only dust extractors
made especially for dangerous dust.
Accessories on page 24 for
Refer to
specifications.
1. Attach the dust extractor (A) to dust extractor
connector (B).
B
2. Start the dust extractor.
Use approved respiratory
Do not use a standard
A
1794 - 003 - 08.03.2024