Husqvarna DM 220 Manuel D'utilisation page 10

4. Push the "TEST" button. If the product stops, the
PRCD operates correctly.
Power switch
The power switch is used to start and stop the product.
To do a check of the power switch
1. Connect the power plug of the product to a power
outlet.
2. Push the power switch to start the product.
To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
10
3. Release the power switch to stop the product.
Safety instructions for maintenance
WARNING:
maintenance should be carried out with
the motor switched off and the plug
disconnected.
• Maintain power tools and accessories. Check for
misalignment or binding of moving parts, breakage
of parts and any other condition that may affect the
power tool's operation. If damaged, have the power
tool repaired before use. Many accidents are caused
by poorly maintained power tools.
• Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
• Have your power tool serviced by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the power tool is
maintained.
Operation
2. Do the daily maintenance. Refer to
schedule on page 18 .
Inspection and/or
Maintenance
1794 - 003 - 08.03.2024