Husqvarna DM 220 Manuel D'utilisation page 15

1. Push the ON/OFF button to start the electronic level
indicator.
2. If it is necessary, do a configuration of the electronic
level indicator. Refer to
electronic level indicator on page 15 .
3. If the middle green LED (A) comes on, the product is
correctly aligned horizontally and vertically.
4. If a red light comes on, the product must be tilted
to adjust the position of the product. Do 1 of the
procedure that follows.
1794 - 003 - 08.03.2024
To do a configuration of the
A
a) If the front red light (B) comes on, tilt up the
product.
b) If the rear red light (C) comes on, tilt down the
product.
c) If the left red light (D) comes on, tilt the product
to the left.
d) If the right red light (E) comes on, tilt the product
to the right.
5. To stop the electronic level indicator temporarily,
push the ON/OFF button. If the ON/OFF button is
pushed again or the power is disconnected, the
electronic level indicator is set to drill in a horizontal
angle.
6. To stop the electronic level indicator, push and hold
the ON/OFF button for approximately 3 seconds.
To do a configuration of the electronic level
indicator
A configuration of the electronic level indicator can be
done to adapt to a specified drill angle.
1. Hold the product at a specified angle.
E
C
B D
15