Publicité
3.
After powering on, click on the password box and enter "123456" to access the factory standby mode
(the password is typically removed before shipment). Refer to the "Standby Interface A" diagram
below.
4.
Verify that the horn size displayed on the screen matches the actual horn size. If adjustment is
needed, click the
below. Modify parameters as required by clicking the relevant boxes and adjusting the values using
the numeric keypad.
Note: Avoid setting parameters to "0."
(The choice of horn should be consistent with the actual installation horn's size)
5.
After setting the parameters, click the
again to start the instrument. To pause the ultrasound operation, click the
cycle finishes and continued operation is needed, click the
To safeguard experimental data, the instrument can store and call 20 sets of parameters (0-19).
Adjust the
6.
If the
box turns yellow during operation, this indicates an over-temperature alarm—— you
need to check if the set temperature is too low. A red
to clear the alarm, click the
EN
button to enter the settings menu, shown in the "Setting Interface B" diagram
Setting interface B
button to enter standby mode. Click the
in the "Settings Interface B" as needed.
box.
Instrument interface description (Rear panel)
button. If a work
button followed by the
box indicates an overload or fault alarm;
button
button.
Publicité
