Publicité
16. Technical Specifications
Model
EM59
Type
EM59-2
Output waveform
Biphasic rectangular pulse
Pulse length
50 - 450 μs
Pulse frequency
1 - 150 Hz
Output voltage max.
100 Vpp (500 ohm)
Output current max.
200 mApp (500 ohm)
Voltage supply
Lithium-ion rechargeable battery,
2000 mAh/3.7V
Treatment time
Adjustable from 5 to 100 minutes
Intensity
Adjustable from 0 to 50
Operating conditions
41° - 104° F (5° - 40° C) at a
relative humidity of 15 - 90%
Storage conditions
32° - 104 °F (0° - 40° C) at a
relative humidity of 0 - 90%
Dimensions
5.5 x 2.6 x 1 inches (139 x 66 x 26
mm) including belt clip
Weight
4.4 oz. (125 g) including belt clip
17. FCC Compliance Information
TENS/EMS device with heat EM 59
Responsible Party – U.S. Contact Information
Beurer North America LP, 1 Oakwood Boulevard, Suite 255,
Hollywood, FL 33020, United States
1-800-536-0366
info@beurer.com
FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and
receiver.
— Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician
for help.
20
Publicité
