Télécharger Imprimer la page

Husqvarna 140 B Manuel D'utilisation page 40

Masquer les pouces Voir aussi pour 140 B:

Publicité

e The fuel quantity required in proportion to the airflow the
Basic setting
throttle trigger position allows is adjusted by means of
The carburettor is adjusted to a basic setting at the factory.
the L- and H-needles. Turning the needles clockwise
The basic setting is richer than the optimum setting and
gives a leaner fuel mixture (less fuel), turning them
shall be maintained during the first working hours.
counter-clockwise gives a richer fuel mixture (more fuel).
Thereafter, do the final setting of the carburettor. The basic
A lean mixture gives higher rpms and a rich one lower
setting can vary between: H = 3/4 —1 turn, L = 3/4 — 1 turn.
T
|
If a lot of fumes come from the muffler at the same time as
s The idling speed screw (T) regulates the position of the
the engine putters a lot the setting is too rich. Turn the H-
throttle lever in the idling speed position. Turning the
nozzle clockwise until the engine stops puttering. Then
idling speed screw clockwise gives a higher idling speed,
open the H-needle until the engine begins to putter slightly.
turning it counter-clockwise gives a lower idling speed.
The carburettor should be set when the machine is fully
assembled and with the air exhaust hose and air intake
completely open.
vete
RENE SC
Eeten
TEE
Wl
sth
TE
dee
bg
E
|
(F) e Les pointeaux L et H permettent de régler le débit de carburan
Réglage de base
nécessaire par rapport à l'air. En tournant les pointeaux dans le
Le réglage de base est effectué en usine. Le réglage de base est
sens d'horloge, le mélange sera plus pauvre (moins de
plus riche que le réglage optimal et devra être maintenu pendant
carburant), en les tournant dans le sens contraire d'horloge, le
les premières heures d'utilisation. Effectuez ensuite un réglage
|
mélange sera plus riche (plus de carburant). Un mélange
final du carburateur. Le réglage de base peut varier entre une
|
pauvre donne un régime plus haut et un mélange riche un
ouverture de H = 3/4 — 1 de tour, L = 3/4 — 1 de tour.
|
être réalisé sur une machine en état de marche, avec le flexible
de sortie et la prise d'entrée entièrement ouverts.

Publicité

loading