Publicité
Installation Instructions
INSTALLING THE COOKTOP
1. INSTALLING THE JUNCTION BOX
Install an approved junction box where it will be easily reached
through the front of the cabinet where the cooktop will be located.
The cooktop conduit is 51"(1.3m) long.
IMPORTANT:
The junction box must be located where it will allow considerable
slack inthe conduit for serviceability.
2. ATTACH FOAM TAPE
Place a towel or tablecloth onto the countertop. Lay the cooktop
upsidedown onto the protected surface.
Apply the foam tape around the outer edge of the glass.
Do not overlap the foam tape.
3. INSTALL THE BRACKETS
Install the four fixed brackets on the
side of the cooktop.
4. INSERT COOKTOP INTO CUTOUT
Insert the cooktop centered into the cutout opening. Make sure the front edge of the
countertop is parallel to the cooktop. Perform a final check to make sure that all
required clearances are met.
5. INSTALLING OVER BUILT-IN OVEN
There must be a minimum of 20mm (13/16") of space left
between the bottom of the cooktop and the oven to allow
air to flow.
There must be a minimum of 5mm (3/16") of space left
between the counter top and the door panel of a built-in
oven / drawer.
If sufficient air flow is not provided, the life of the appli-
ance will be shortened.
Countertop
Screw
Bracket
18
Install junction box so
that it can be reached
through the front of the
cabinet.
Bottom of Cooktop
FoamTape
Foam Tape
Cooktop Glass
Cooktop
Cooktop Base
5
/127mm
Min.
min.
5mm(3/16")
Publicité
