Publicité
INSTALLATION INSTRUCTIONS
We recommend you have the electrical wiring and hookup of your cooktop connect-
ed by a qualified electrician. After installation, have the electrician show you where
your main cooktop disconnect is located.
Wiring must conform to National Electrical Code. In the U.S.- National Electrical
Code, ANSI/NFPA No. 70- Latest Edition.
In Canada, wiring must conform to the Canadian Electrical Code (CEC).
The cooktop conduit wiring is approved for copper wire connection only, and if you
have aluminum house wiring, you must use special UL approved connectors for
joining copper to aluminum. In Canada, you must use special CSA approved
connectors for joining copper to aluminum.
You must use a two-wire, three conductor 208/240 VAC, 60 Hertz electrical system.
A white (neutral) wire is not needed for this unit. The cooktop must be installed in a
circuit that does not exceed 125 VAC nominal to ground.
Refer to the name plate on your cooktop for the KW rating for your cooktop.
PRE-INSTALLATION CHECKLIST
The electrical power to the cooktop supply line must be shut off
WARNING
while connections are being made. Failure to do so could result in serious injury or
death.
A. When preparing cooktop opening, make sure the inside of the cabinet and the
cooktop do not interfere with each other. (See section on preparing the opening.)
B. Remove packaging materials and literature package from the cooktop before
beginning installation.
C. Remove Installation Instructions from the document pack and read them carefully
before you begin. Be sure to place all the documents, Owner's Manual, Installations,
etc. in a safe place for future reference.
D. Make sure you have all the tools and materials you need before starting the
installation of the cooktop.
E. Your home must provide the adequate electrical service needed to safely and
properly use your cooktop. (Refer to section on electrical requirements.)
F. When installing your cooktop in your home, make sure all local codes and
ordinances are followed exactly as stated.
G. Make sure the wall coverings, countertop and cabinets around the cooktop can
withstand heat (up to 200°F/ 94°C ) generated by the cooktop.
Parts Included
• Foam Tape
• 4 Brackets
• 4 Screws
16
Publicité
