Publicité
INSTALLATION INSTRUCTIONS
BEFORE YOU BEGIN Read these instructions completely and carefully.
• IMPORTANT— Save these instructions for local inspector's use.
• IMPORTANT— Observe all governing codes and ordinances.
• Note to Installer – Be sure to leave these instructions with the Consumer.
• Note to Consumer – Keep these instructions for future reference.
• Product failure due to improper installation is not covered under the Warranty.
WARNING : This appliance must be properly grounded.
• ATTENTION INSTALLER — ALL COOKTOPS MUST BE HARD WIRED
(DIRECT WIRED) INTO AN APPROVED JUNCTION BOX. A "PLUG AND
RECEPTACLE" IS NOT PERMITTED ON THESE PRODUCTS.
• Proper installation is the responsibility of the installer and product failure due to
improper installation is NOT covered under warranty.
IMPORTANT SAFETY INSTRUCTIONS
FOR YOUR SAFETY
• For personal safety, remove the house fuse or open circuit breaker before
beginning installation. Failure to do so could result in serious injury or death.
• Be sure your cooktop is installed properly by a qualified installer or service technician.
• To eliminate the risk of burns or fire due to reaching over heated surface elements,
cabinet storage located above the surface units should be avoided. If cabinet storage
space is to be provided, the risk can be reduced by installing a range hood that
projects horizontally a minimum of 5"/127mm beyond the bottom of the cabinets.
Cabinet installation above the cooktop may be no deeper than 13" / 330mm.
• Make sure the cabinets and wall coverings around the cooktop can withstand the
temperatures (up to 200°F/ 94°C) generated by the cooktop.
• The cooktop should be easy to reach and lighted with natural light during the day.
• Always disconnect the electrical service to the cooktop before repairing or servicing
the cooktop.This can be done by disconnecting the fuse or circuit breaker. Failure to
do this could result in a dangerous or fatal shock. Know where your main disconnect
switch is located. If you do not know, have your electrician show you.
ELECTRICAL REQUIREMENTS
This appliance must be supplied with the proper voltage and frequency, and
connected to an individual, properly grounded branch circuit, protected by a circuit
breaker or a time delay fuse as noted on name plate.
15
Publicité
