Jonsered CS 2145 Manuel D'utilisation page 38

RECOMMENDED CUTTING EQUIPMENT FOR CANADA
The following is a list of recommended cutting equipment for Class 1A and 1B Chainsaws. The combinations of powerhead, bar
and chain meet all requirements outlined in the CSA Z62.1-95 Chainsaws and Z62.3-96 Chainsaw Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the corresponding
maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list. For guide
bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of sprocket teeth may be
considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent or less
kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which are available
at your dealer.
Length, inch Pitch, inch
13 0,325
15 0,325
16 0,325
18 0,325
13 0,325
15 0,325
16 0,325
18 0,325
Note: For the chains above you are free to choose between 0,050", 0,058" and 0,063" gauge drive link for the corresponding bar,
see the table below.
0,050"/1,3 mm S30/95VP
0,058"/1,5 mm -
0,063"/1,6 mm -
Saw chain filing and file gauges
38 –
Canadian
All manuals and user guides at all-guides.com
TECHNICAL DATA
Bar
Gauge, inch Max. nose radius
1,3 10T
10T
10T
10T
1,5 10T
10T
10T
10T
20BP
S25/21BP
22BP
Chain
Type Drive link count
Jonsered H30 56
64
66
72
Jonsered H25 56
64
66
72