Télécharger Imprimer la page

BWT BC200 Manuel D'utilisation page 9

Publicité

EMPTYING THE DEBRIS COMPARTMENT
WARNING! Using the robot without its filter cover in place will VOID your warranty.
In order to maximize the cleaning efficiency, clean the debris compartment and the filter cover before and after each use.
CAUTION! Before cleaning the debris compartment, make sure the robot is OFF.
1. Place the cleaner on a flat surface. Pull one side clip outwards to lift one side of the cover and repeat the steps on the other
side to lift the entire top cover to expose the filter cover.
2
1
2. Detach the filter cover and remove the debris from the compartment. It is recommended to clean the filter cover net with
splashing water. If brushing is deemed necessary, use only a soft brush to clean it carefully and gently to avoid damages.
3. After cleaning, make sure that the filter cover is in place and the body top cover is correctly installed and secured by the
side clips.
CAUTION!
- Replace a damaged filter cover immediately with a new one before the next operation.
- Replace a damaged float immediately with a new one before the next operation.
Float Replacement
Use a screwdriver ( not provided ) to unscrew the 4 screws at on the top cover of the swivel head. Untie the knot on the string
to remove the damaged float. Ensure the round switch is in place before sliding the string of the new float through the top cover
and tying a knot to keep it in place, and then re-install the top cover with screws.
- Replace a damaged flap immediately with a new one before the next operation.
bwt.com
MAINTENANCE & CLEANING
4
3
8/147
2021/10 : A

Publicité

loading

Ce manuel est également adapté pour:

Bc200+Bc serie