- Under no circumstances should you disassemble the swivel head to replace its internal components
by yourself. Doing so would void the warranty, expose yourself to potential hazards, and possibly
damage the device and other properties.
- Never insert fingers or any object to touch the impeller.
- The built-in battery must be removed by a skilled technician before it is scrapped.
- This robot contains a battery that are only to be removed by skilled persons.
- The robot must be disconnected from the supply mains as the battery is removed.
- For details regarding battery recycling/disposal, refer to the section "BATTERY DISPOSAL" in this
manual and contact your local authorities for more information.
- The battery must be disposed safely in accordance with local ordinances or regulations.
- External adaptor and charging plug:
• Never use the external adaptor and charging plug for anything other than charging the battery of
the robot that is supplied in the same pack.
• The external adaptor and charging plug should not be used outdoors, nor should it be exposed to
rain, humidity, and any liquid or heat.
• The transformer ( or external adaptor ) is to be located outside zone 1.
• Keep the external adaptor and charging plug out of reach of children.
• Never use the external adaptor and charging plug if any damage is detected.
• DO NOT handle the external adaptor and charging plug with wet hands.
• Keep the external adaptor disconnected from power when it is not in use.
• Never attempt to pry open the external adaptor.
• If the supply cord of the external adaptor is damaged, the external adaptor must be replaced by
the manufacturer or its service agent to prevent hazards of any kind.
• Make sure the robot is completely dry before charging.
CAUTION!
- This robot is designed for underwater use only; it is not an all-purpose vacuum cleaner. DO NOT attempt to use it to clean
anything other than your pool.
- Use only the original accessories delivered with this product.
- DO NOT use this robot right after pool-shocking. It is recommended to first leave the pool circulating for at least 24 - 48 hours.
- If you are planning on using the robot in a saltwater pool, make sure all salt are dissolved before deploying the robot.
- DO NOT use this robot with another automatic cleaner/cleaner simultaneously in the pool.
- Remove hard, sharp objects from the pool before deploying the robot to avoid damages to the robot and its filter.
- To avoid damages to the external adaptor and charging plug, do not attempt to carry the robot by the cord of external
adaptor / charging plug or pull the cord to disconnect it from the power source and charging plug.
- Charge the robot indoors in a clean, dry area with good ventilation and away from sunlight.
- DO NOT leave the robot charged for over 10 hours.
- If the robot will not be used for an extended period, detach it from the charging plug and use a damp cloth to clean and dry
the robot and its accessories. Make sure to charge the robot to about 30% to 50% of the battery capacity before it is stored.
Store it in a well-ventilated area away from sunlight, heat, ignition sources, pool chemicals, and children. Recharge the
robot every three months.
- All actions concerning the disassembly of the swivel head ( ie. battery disposal ) should only be carried out by an authorized
technician.
Above warnings and cautions are not intended to incorporate all possible instances for risks and / or severe
injuries. Pool / spa owners should always exercise extra caution and common sense when utilizing the product.
Remark: Product/parts photos/drawings in this manual are for demonstration only. Product/parts in photos / draw-
ings may vary with the model purchased. Accessories / parts shown in this manual & parts diagram are not necessar-
ily included with every model.
bwt.com
MAINTENANCE & CLEANING
2/147
2021/10 : A